DTC B1009: EEPROM Checksum Error: Description

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Description
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

EEPROM check sum error detection is handled inside control module. No external circuits are involved. Control module compares its previously stored checksum with checksum calculated when ignition switch is first turned to RUN position. When DTC B1009 is stored, control module will operate from preset critical operating data for those blocks of data that have failed check sum test. Blocks of data that have not failed check sum test are not affected. DTC will clear when control module runs a successful check sum test of EEPROM.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.