Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 127 (ENGINE CONTROLS - SYSTEM & COMPONENT TESTING)FUEL SYSTEMSFUEL INJECTOR COIL TESTTEST DESCRIPTION
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8
Test Description
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Test Description
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to step numbers in diagnostic procedure.
- 3 - This step tests each fuel injector resistance within a specific temperature range. If any fuel injectors display a resistance outside of specified value, replace fuel injector.
- 4 - This step determines if all fuel injectors are within 3 ohms of each other. If highest resistance value is within 3 ohms of lowest resistance value, then all fuel injector coil windings are okay.
- 6 - This step determines if the ignition 1 voltage circuit under the intake plenum is causing the concern.
- 8 - This step determines which fuel injector is faulty. After subtracting highest and lowest resistance values from average value, replace fuel injector that has greatest resistance difference from average.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.