Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
The DTC P0340 Camshaft Position (CMP) sensor circuit diagnostic monitors the signal from CMP sensor. CMP sensor is a magnetic generator type sensor that produces an AC signal. CMP sensor signal increases in frequency as engine RPM increases. CMP signal is used by Powertrain Control Module (PCM) to determine optimum ignition timing and optimum fuel delivery. CMP sensor is also used to monitor engine misfire and monitor operation of CMP actuator system.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.