SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.7 R, L31/KL8REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (AUTOMATIC TRANSMISSION SERVICING)REMOVAL & INSTALLATIONSHIFT CABLEINSTALLATION
2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8

Shift Cable: Installation

2001 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.7 R, L31/KL8SECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift cable through the hole in the dash. See Figure .
  2. Install the shift cable through the console shift control bracket.
  3. Install the shift cable to the console shift control.
  4. Install the shift cable retainer to the console shift control.
  5. Install the shift cable to retaining clip(s) or retainer(s) in the passenger compartment.
  6. Install the carpet into position. Install the front floor console. See appropriate SHIFT INTERLOCK SYSTEMS article.
  7. Properly route and position the shift cable. See Fig 1 .
  8. Install the shift cable to the shift cable bracket. See Figure .
  9. Install the shift cable to the Park/Neutral position switch. See Figure .
  10. Place the transaxle in the Neutral position. Place the shift control in the Neutral position.
  11. Connect each cable section to the following before connecting the 2 cable sections.
  12. Insert the metal end fitting of the shift control cable into the transaxle cable end. See Figure .
  13. Use the molded end fittings to push the metal end fitting of the shift control cable and the transaxle cable end together until the metal post snaps into place.
  14. Depress the adjuster clip once. This mobilizes the adjuster housing toward the transaxle end fitting.
  15. Line up the end fittings so they slide together until you feel the parts cam together and lock.
  16. Depress the adjuster clip completely. This locks the cable into its adjusted service position.
  17. Pull the conduit in the opposite direction to assure full system adjustment of the shift cable.
  18. The horseshoe clip with the tab is flush when fully engaged. Ensure the conduit is fully engaged
  19. The horseshoe clip with the tab is not flush when not fully engaged.
  20. Install the shift cable retainer and the wiring harness clip or the wiring harness strap.
  21. Adjust the shift cable. See SHIFT CABLE  under ADJUSTMENTS.
  22. Install the throttle body air inlet duct.
Fig 1: Identifying Shift Cable Routing
G00087699Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.