Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the engine mount to the vehicle.
- Align the engine mount (2) to the mount bracket using a dowel (1).
- Hand tighten the engine mount to body nuts (1). See Figure.
- Install the engine mount (2) to bracket bolts (1). See Figure.
Tighten
Tighten the engine mount to body nuts and the engine mount to bracket bolts to 55 N.m (41 lb ft).
Tighten
Tighten the engine mount bolts to 110 N.m (81 lb ft).
- Install the A/C low pressure line retaining bracket (1) nut. See Figure.
Tighten
Tighten the nut to 10 N.m (89 lb in).
- Install the cruise control module mounting nuts.
Tighten
Tighten the nuts to 10 N.m (89 lb in).
- Remove the floor jack.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.