SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 95 (ENGINE MECHANICAL - 2.2L)REPAIR INSTRUCTIONSOFF-VEHICLE REPAIR INSTRUCTIONSENGINE PRELUBINGTOOLS REQUIRED
2001 Chevrolet Cavalier LS, 2.4 T

Tools Required

2001 Chevrolet Cavalier LS, 2.4 TSECTION Tools Required
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

J 45299  Engine Preluber

Important:  A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.

  1. Locate the oil pressure switch and remove.
  2. Install the M12 x 1.75 adapter P/N 509376
    Fig 1: Removing Oil Pressure Switch
    G01580756Courtesy of GENERAL MOTORS CORP.
  3. Install the flexible hose to the adapter and open the valve.
  4. Pump the handle on the J 45299  in order to flow a minimum of 1-1.9 liters (1-2 quarts) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
  5. Close the valve and remove the flexible hose and adapter from the engine.
  6. Install the oil pressure switch to the engine.

    Tighten 

    Tighten the oil pressure switch to 22 N.m (16 lb ft).

  7. Top-off the engine oil to the proper level.
    Fig 2: Identifying Engine Pre-Luber
    G01580757Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.