Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 9 (Steering Column And Steering Column Switches): Description
All vehicles are equipped with tilt columns, with tilt lever located on lower left side of column. Multifunction switch is integral of lever on left side of column. Multifunction switch controls turn signals, headlight high/low beam, headlight flash-to-pass and cruise control functions. Lever on right side of column contains all windshield wiper/washer switch functions.
Some models are equipped with electronic telescoping column, allowing fore and aft movement of steering wheel. If equipped, self-diagnostics are available for isolating faults with this system.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.