Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 87 (ENGINE CONTROL SYSTEM - PID VALUES, PCM CONNECTOR VIEWS & TERMINAL IDENTIFICATION)PID VALUE CHARTS
2001 Chevrolet Cavalier LS, 2.4 T
PID Value Charts
2001 Chevrolet Cavalier LS, 2.4 TSECTION PID Value Charts
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery.
Ensure following conditions are met before comparing scan tool data to typical data value found in appropriate PID value chart:
- Engine is idling unless checking a value at a specified RPM.
- Throttle is closed unless checking a value at a specified RPM.
- Vehicle is in Park or Neutral.
- Vehicle is operating in closed loop.
- Vehicle accessories are turned off.
Compare actual PID values on scan tool to PID values found in appropriate PID value chart.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.