Air Cleaner Intake Duct: Installation

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Combine the air cleaner intake duct and Mass Air Flow/Intake Air Temperature (MAF/IAT) sensor. Install the air cleaner intake and MAF/IAT assembly on the throttle body and air cleaner cover. Inspect for proper alignment of the air cleaner intake and MAF/IAT assembly and tighten the hose clamps.
  2. Tighten the air cleaner intake and MAF/IAT assembly clamps to specification. See TORQUE SPECIFICATIONSΒ . Connect the MAF/IAT sensor electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.