Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 8 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 5.7L)DIAGNOSTIC TESTSDTC P0602: PCM NOT PROGRAMMEDDIAGNOSTIC PROCEDURES
2001 Chevrolet Cavalier LS, 2.4 T
Diagnostic Procedures
2001 Chevrolet Cavalier LS, 2.4 TSECTION Diagnostic Procedures
WARNING: This page is about a different car, the 2000 Pontiac Firebird, 2000 Chevrolet Corvette, and 2000 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. After performing OBD system check, go to next step.
- Flash PCM with current software. If DTC is reset, go to next step. If DTC does not reset, go to step 5.
- Verify that test equipment used is operating properly and that all connections are clean and tight. Attempt to flash PCM again. If DTC resets, go to next step. If DTC does not reset, go to step 5.
- Replace PCM. Program replacement PCM using required equipment. After replacing PCM, go to next step.
- Using scan tool, select DTC, CLEAR INFO function. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, repeat step 2.
- Using scan tool, select CAPTURE INFO, REVIEW INFO function. If any undiagnosed DTCs are displayed, go to applicable DTC test.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.