Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 68 (ENGINE CONTROLS - TROUBLE SHOOTING - NO CODES - 2.2L)SYMPTOMSPOOR FUEL ECONOMYSENSOR/SYSTEM
2001 Chevrolet Cavalier LS, 2.4 T
Poor Fuel Economy: Sensor/System
2001 Chevrolet Cavalier LS, 2.4 TSECTION Sensor/System
WARNING: This page is about a different car, the 2003 Pontiac Sunfire, 2003 Pontiac Grand Am, 2003 Oldsmobile Alero, and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Check for the following that may cause the engine to run rich:
- Any water intrusion in the HO2S connector.
- The engine oil contaminated by fuel.
- An EVAP canister purge condition.
- Incorrect fuel pressure. Go to FUEL PRESSURE TEST under FUEL SYSTEMS (GASOLINE) in BASIC DIAGNOSTIC PROCEDURES - 2.2L ALERO, CAVALIER, GRAND AM & SUNFIRE article.
- A leaking fuel pressure regulator. Go to FUEL SYSTEM DIAGNOSIS (GASOLINE) under FUEL SYSTEMS in BASIC DIAGNOSTIC PROCEDURES - 2.2L ALERO, CAVALIER, GRAND AM & SUNFIRE article.
- Any leaking fuel injectors. Go to FUEL SYSTEM DIAGNOSIS (GASOLINE) under FUEL SYSTEMS in BASIC DIAGNOSTIC PROCEDURES - 2.2L ALERO, CAVALIER, GRAND AM & SUNFIRE article.
- Any vacuum hoses that are split, kinked, or improperly connected.
- An air intake duct that is collapsed or restricted.
- An air filter that is dirty or restricted.
- Check the air intake system and crankcase for air leaks.
- Check for an Engine Coolant Temperature (ECT) sensor that has shifted in value. Go to TEMPERATURE VS. RESISTANCE table.
- Check the crankcase ventilation system for proper operation.
- Check for an inaccurate speedometer.
- Use a scan tool to monitor the Knock Sensor (KS) system for excessive spark retard activity.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.