Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (ENGINE CONTROL SYSTEM - SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P0446: EVAP VENT SYSTEM PERFORMANCEDIAGNOSTIC AIDS
2001 Chevrolet Cavalier LS, 2.4 T
Diagnostic Aids
2001 Chevrolet Cavalier LS, 2.4 TSECTION Diagnostic Aids
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- If DTC P0446 is the only EVAP DTC set, the most likely cause is an inoperable EVAP canister vent solenoid, or pressure switching solenoid. Check EVAP solenoids carefully for faulty connections and erratic operation.
- An intermittent malfunction may be caused by a fault in any of EVAP solenoid electrical circuits. Check wiring harness and components for an intermittent condition.
- If DTC cannot be duplicated, information included in freeze frame data can be useful in determining vehicle operating conditions when DTC was first set.
- Operating vehicle in CHECK MODE will increase ability of PCM module to detect engine control system malfunctions. See SERVICE BAY TESTS under SELF-DIAGNOSTIC SYSTEM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.