Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (POWER WINDOW SYSTEM)SYMPTOM TESTSTEST 2: RIGHT WINDOW INOPERATIVE FROM MASTER SWITCH
2001 Chevrolet Cavalier LS, 2.4 T
Test 2: Right Window Inoperative From Master Switch
2001 Chevrolet Cavalier LS, 2.4 TSECTION Test 2: Right Window Inoperative From Master Switch
WARNING: This page is about a different car, the 2000 Chevrolet Corvette and 1999 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Using scan tool, check Left Door Control Module (LDCM) history for DTCs. If DTC B2205, B2206 or B2208 is retrieved, perform appropriate test under DIAGNOSTIC TESTS . If no DTCs are retrieved, go to next step.
- Depress right window switch to UP and DOWN positions. If right window operates, go to next step. If window does not operate, go to RIGHT WINDOW INOPERATIVE .
- Depress right window switch on master switch assembly to UP and DOWN positions. If right window operates up and down, system is okay. If right window does not operate, go to next step.
- Using scan tool, select LDCM inputs and monitor right window switch status. Depress right window switch on master switch assembly to UP position. If scan tool displays ACTIVE, go to next step. If scan tool does not display ACTIVE, go to step 7 .
- Using scan tool, select LDCM inputs and monitor right window switch status. Depress right window switch on master switch assembly to DOWN position. If scan tool displays ACTIVE, system is okay. If scan tool does not display ACTIVE, go to next step.
- Check for open in Tan wire or Black wire between LDCM and master switch assembly. If circuits are okay, go to step 8 . If circuits are not okay, repair as necessary. After repair, go to step 9 .
- Check for open in Light Blue wire or Black wire between LDCM and master switch assembly. If circuits are okay, go to next step. If circuits are not okay, repair as necessary. After repair, go to step 9 .
- Replace master switch assembly. See WINDOW SWITCH under REMOVAL & INSTALLATION.
- Turn ignition switch to OFF position. Reconnect or install any connectors or components that were disconnected or removed. Turn ignition switch to RUN position. Clear any DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES (DTCS) under SELF-DIAGNOSTIC SYSTEM. Recheck system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.