Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1441: EVAP System Flow During Non-Purge: Description
Evaporative Emission (EVAP) system is used to store fuel vapors as to reduce amount or unburned fuel from escaping into atmosphere. EVAP purge solenoid is used to control flow of fuel vapors from EVAP canister to intake manifold. EVAP purge solenoid is commanded on (PWM) whenever EVAP system is in purge mode. Fuel vapors can be purged at anytime PCM is in closed loop and vehicle is not in a decel. PCM controls EVAP purge solenoid by controlling an internal driver that pulls solenoid circuit to ground. EVAP purge solenoid circuit is monitored for low and high voltage faults. During one part of EVAP diagnostic system test, PCM will close EVAP purge solenoid and EVAP vent solenoid. DTC sets when fuel tank pressure sensor indicates that pressure is lower than atmospheric (vacuum) indicating EVAP purge solenoid is stuck open.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.