Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 357 (SEAT BELT SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2001 Chevrolet Cavalier LS, 2.4 T
Fastener Tightening Specifications
2001 Chevrolet Cavalier LS, 2.4 TSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Center Rear Seat Belt Retractor Bolt | 28 N.m | 21 lb ft |
| Child Seat Latch Bracket Bolt | 26 N.m | 17 lb ft |
| Child Tether Anchor Bolt | 28 N.m | 21 lb ft |
| Front Seat Belt Buckle Bolt - Left | 34 N.m | 25 lb ft |
| Front Seat Belt Buckle Bolt - Right | 48 N.m | 35 lb ft |
| Front Seat Belt Retractor Anchor Plate Bolt | 48 N.m | 35 lb ft |
| Front Shoulder Belt Guide Bolt | 41 N.m | 30 lb ft |
| Front Seat Belt Retractor Bolt | 48 N.m | 35 lb ft |
| Front Shoulder Belt Guide Track Bolt | 28 N.m | 21 lb ft |
| Rear Seat Belt Buckle Nut | 50 N.m | 37 lb ft |
| Rear Seat Belt Anchor Plate Bolt | 48 N.m | 35 lb ft |
| Rear Seat Belt Retractor Bolt | 28 N.m | 21 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.