Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 356 (BODY REAR END)REPAIR INSTRUCTIONSTORQUE ROD REPLACEMENT - REAR COMPARTMENT LIDREMOVAL PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When a hood hold open device is being removed or Installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Prop the compartment lid (2) in the full-open position.

Fig 1: Identifying Compartment Lid In Full-Open Position
Courtesy of GENERAL MOTORS CORP.
Use the J 39719 , the J 39384-10 or the equivalent (6) in order to remove the torque rod (5) from the adjusting notch.
With the torque rod removed from the adjuster notch, push the rod out of the hinge arm.

Fig 2: Removing Torque Rod From Adjusting Notch
Courtesy of GENERAL MOTORS CORP.
Remove the torque rod (1) from the rear compartment lid hinge (4).

Fig 3: Removing Torque Rod From Rear Compartment Lid Hinge
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.