Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panel (2) to the lower quarter panel.
  2. Align the trim panel retainers with the openings in the lower quarter panel.
  3. Press the trim panel (2) firmly and evenly in order to engage the retainers to the lower quarter panel.
  4. Install the push retainer (1) to the trim panel (2).
  5. Return the rear seat back to its upright position.
  6. Install the rear quarter upper trim panel. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER UPPERΒ  .
  7. Install the rear seat cushion. Refer to SEAT CUSHION REPLACEMENT - REAR in Seats.
    Fig 1: Installing Push Retainer To Trim Panel
    G01559958Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.