Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 354 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK RECLINER REPLACEMENT - FRONT (AR9)INSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the recliner to the seat.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the recliner bolts (1, 2)
Tighten

Tighten the bolts to 20 N.m (15 lb ft).
Install the seat back pad and cover to a desired appearance.
Fasten the J-hook retainer located next to the SIAB module, if equipped.
Fasten the J-hook retainer located at the bottom of the seat back cover.
Install the outer trim panel on the seat cushion. Refer to SEAT CUSHION OUTER TRIM PANEL REPLACEMENT .
Install the bucket seat. Refer to SEAT REPLACEMENT .
Reposition the seat back to the original position.
Check the seat back recliner for proper operation.
Enable the SIR system, if equipped with SIAB. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM or to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.

Fig 1: Installing Recliner Bolts
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.