Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the window to the full DOWN position.
  2. Remove the door outer belt sealing strip. Refer to SEALING STRIP REPLACEMENT - FRONT DOOR WINDOW BELT OUTERΒ  or SEALING STRIP REPLACEMENT - REAR DOOR WINDOW BELT OUTERΒ  .
  3. Pull the door window channel retainer at the door window frame applique (1) in order to access the door window frame applique screws (2).
  4. Remove the screws (2) from the door window frame applique.
  5. Pull and slide the door window frame applique in order to disengage the applique (1) from the door.
    Fig 1: Removing Door Window Frame Applique From Door
    G01559770Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.