SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 349 (RETAINED ACCESSORY POWER)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2001 Chevrolet Cavalier LS, 2.4 T

Scan Tool Data Definitions

2001 Chevrolet Cavalier LS, 2.4 TSECTION Scan Tool Data Definitions
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Use the Scan Tool Data Display Values and Definitions Information in order to assist in diagnosing vehicle malfunctions. Compare the vehicles actual scan tool data with the typical data display value table information. Use the data information in order to aid in understanding the nature of the problem when the vehicle does not match with the typical data display values.

The scan tool data values were taken from a known good vehicle under the following conditions:

  • The ignition switch is in the ON position.
  • The engine is not running.
  • The vehicle is in PARK.

Accessory:  The BCM uses this data in order to determine the position of the ignition switch. ON is displayed when the ignition switch is in the ON or ACCY position.

Battery Voltage:  This voltage value refers to the battery system voltage.

Driver Door Ajar Sw.:  The scan tool displays On/Off. On is displayed when the driver door is open, Off when closed.

Ignition 1:  The BCM uses this data in order to determine the position of the ignition switch. ON is displayed when the ignition switch is in the ON or CRANK position.

Key In Ignition:  This information refers to whether or not the ignition key is inserted into the ignition switch. The BCM uses this data to perform chime functions. ON is displayed when the key is inserted into the ignition switch.

Passenger Door Ajar Sw.:  The scan tool displays On/Off. On is displayed when at least one passenger door is open, Off when all passenger doors are closed.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.