Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear window panel trim. Refer to TRIM PANEL REPLACEMENT - REAR WINDOW SHELF in Interior Trim.
  2. Press the tab on the front of the rear speaker spacer (3).
  3. Remove the speaker spacer (3) lifting up and out.
  4. Disconnect the electrical connector (1) from the speaker (2).
  5. Remove the rear speaker spacer (3) from the vehicle.
    Fig 1: Removing Rear Speaker From Rear Shelf
    G01559092Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws (1) from rear speaker (3).
  7. Remove the rear speaker (3) from the spacer (2).
    Fig 2: Removing Screws From Rear Speaker
    G01559093Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.