Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the antenna leads (2) through the opening in the vehicle roof (4).
  2. Align the locating pin (5) on the antenna base (1) to the vehicle roof.
  3. Install the antenna base (1) to the vehicle roof.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the antenna mounting nut (3).

    TightenΒ 

    Tighten the nut to 6 N.m (53 lb.in).

  5. Install the power sunroof motor/actuator. Refer to SUNROOF MOTOR/ACTUATOR REPLACEMENT in Roof.
  6. Connect the antenna lead (2) to headliner wire harness assembly.
  7. Press the connector until the locking tabs are fully engaged.
  8. Install the headliner. Refer to HEADLINER REPLACEMENT in Interior Trim.
    Fig 1: Installing Digital Radio Antenna
    G01559085Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.