Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 340 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER TRANSMISSION REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Position the wiper transmission to the wiper drive system module tube frame.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the wiper transmission screws.
Tighten

Tighten the screws to 9 N.m (79 lb in).
Install the wiper transmission caps.

Fig 1: Installing Wiper Transmission To Wiper Drive System Module Tube Frame
Courtesy of GENERAL MOTORS CORP.
Using the J 39529, connect the wiper transmission to the wiper motor crank arm.

Fig 2: Connecting Wiper Transmission To Wiper Motor Crank Arm
Courtesy of GENERAL MOTORS CORP.
Position the wiper drive system module to the vehicle.
Install the wiper drive system module screws.
Tighten

Tighten the screws to 10 N.m (89 lb in).
Connect the wiper motor electrical connector.
Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in Body Front End.
Inspect the wipers for proper operation.

Fig 3: Installing Wiper Drive System Module
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.