Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 339 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL LAMP REPLACEMENT (CHEVROLET)INSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T
Installation Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to ELECTRICAL WIRING ROUTING NOTICE
in Cautions and Notices.
- Install the tail lamp to the quarter panel.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the tail lamp nuts (2) to the tail lamp.
Tighten
Tighten the tail lamp nuts (2) to 5 N.m (44 lb.in).
- Connect the electrical connector (1) to the tail lamp.
- Install the bulb to the socket, if required.
- Install the bulb /socket to the tail lamp.
- Pull back the rear compartment trim. Refer to COMPARTMENT TRIM PANEL REPLACEMENT - REAR in Body Rear End.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.