Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fog lamp (1) to the front bumper fascia.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the nuts (2) to the fog lamp.

    TightenΒ 

    Tighten the fog lamp nuts to 2 N.m (18 lb.in).

  3. Install the fog lamp bulb/socket to the fog lamp.
    Fig 1: Installing Fog Lamp To Front Bumper Fascia - Front (Pontiac)
    G01558911Courtesy of GENERAL MOTORS CORP.
  4. Install the front fender liner. Refer to FRONT FENDER LINER REPLACEMENT in Body Front End.
    Fig 2: Identifying Front Fender Liner - Front (Pontiac)
    G01558912Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.