Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to HALOGEN BULB CAUTION In Cautions and Notices.
  1. Partially remove the front edge of the front fender liner to gain access to the fog lamps. Refer to FRONT FENDER LINER REPLACEMENT in Body Front End.
  2. Remove the fog lamp bulb/socket from the fog lamp.
  3. Remove the nuts (2) from the fog lamp.
    Fig 1: Locating Fog Lamp Nuts - Front (Chevrolet)
    G01558913Courtesy of GENERAL MOTORS CORP.
  4. Remove the fog lamp from the front bumper fascia.
    Fig 2: Removing Fog Lamp From Front Bumper Fascia - Front (Chevrolet)
    G01558914Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.