Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 32 (ELECTRICAL COMPONENT LOCATOR)CONNECTORS
2001 Chevrolet Cavalier LS, 2.4 T
Section 32 (Electrical Component Locator): Connectors
2001 Chevrolet Cavalier LS, 2.4 TSECTION Connectors
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
CONNECTORS LOCATION
| Component | Location |
|---|---|
| C100 (Gray/Black, 38 Pin) | At left side of engine compartment. |
| C101 (Black, 15 Pin) | At left front of engine compartment. |
| C102 (Black, 8 Pin) | Near throttle body. |
| C103 (Gray, 14 Pin) | On automatic transmission. |
| C104 (2.2L VIN F) (Gray, 2 Pin) | Near rear of cylinder head. |
| C200 (Black, 23 Pin) | Behind left end of dash. |
| C201 (Black/Yellow, 3 Pin) | Near left "A" pillar. |
| C202 (Black, 6 Pin) | Behind left end of dash. |
| C203 (Black, 3 Pin) | Behind left side of dash. |
| C204 (Black, 8 Pin) | Behind right side of dash. |
| C206 (Yellow, 2 Pin) | At lower dash tie bar. |
| C207 (Yellow, 2 Pin) | At lower dash tie bar. |
| C208 (Black, 6 Pin) | Near fog light relay. |
| C220 (Green, 6 Pin) | Behind left end of dash. |
| C313 (Light Gray/Black, 16 Pin) | Under center of rear seat. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.