Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 294 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER TRANSMISSION REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wiper Drive System Module To Wiper Motor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Position the wiper transmission to the wiper motor module assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the wiper transmission screws.
Tighten: Tighten the screws to 10 N.m (89 lb in).

Fig 2: Wiper Transmission To Wiper Motor Crank Arm

Courtesy of GENERAL MOTORS CORP.

Using the J 39529 , connect the wiper transmission to the wiper motor crank arm.
Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
Install the wiper arms. Refer to Wiper Arm Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.