Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Washer Hoses At Bottom Side & Windshield
    GM70096Courtesy of GENERAL MOTORS CORP.
  1. Position the air inlet screen to the opening.
  2. Install the windshield washer hoses to the under side of the screen.
  3. Install the screen by engaging the screen clips under the edge of the windshield.
  4. Fig 2: Push-In Retainers At Engine Edge
    GM171177Courtesy of GENERAL MOTORS CORP.
  5. Secure the engine side of the screen with the push-in retainers.
  6. Install the wiper arms. Refer to Wiper Arm Replacement in Wipers/Washers Systems.
  7. Fig 3: Plenum To Hood Seal
    GM71296Courtesy of GENERAL MOTORS CORP.
  8. Install the plenum to hood seal.
  9. Close the hood.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.