Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 283 (BODY REAR END)REPAIR INSTRUCTIONSLATCH REPLACEMENT - REAR LIFT WINDOW PANELINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Harness At Latch

Courtesy of GENERAL MOTORS CORP.

Position the latch to the latch bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts attaching the latch.
Tighten: Tighten the latch mounting bolts to 10 N.m (89 lb in).
Connect the electrical harness to the latch.

Fig 2: View Of Cargo Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the cargo lamp to the trim panel.

Fig 3: Rear Floor Side Stowage Compartment Cover

Courtesy of GENERAL MOTORS CORP.

Install the rear/end corner carpet trim panel. Refer to Trim Panel Carpet Replacement - Rear Corner (Coupe) or Trim Panel Carpet Replacement - Rear Corner (Convertible) or Trim Panel Carpet Replacement - Rear Corner (Hardtop) in Interior Trim.
Install the rear floor side stowage compartment cover.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.