Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 276 (INSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLE)REPAIR INSTRUCTIONSCONSOLE COMPARTMENT DOOR HINGE REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hinge To Console

Courtesy of GENERAL MOTORS CORP.

Position the console door hinge to the console.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts retaining the door hinge to the console.
Tighten: Tighten the console door hinge retaining nuts to 2.4 N.m (21 lb in).

Fig 2: Console Door To Door Hinge

Courtesy of GENERAL MOTORS CORP.

Position the console door to the door hinge.
Insert both door alignment pins into the hinge alignment holes.
Install the screws retaining the console door to the door hinge.
Tighten: Tighten the console door retaining screws to 1.9 N.m (17 lb in).
Install the console to the vehicle. Refer to Console Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.