Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 273 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL/BACKUP LAMP REPLACEMENT (EUROPE)INSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T
Installation Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bulbs to the lamp sockets, if replacing the bulbs.
- Install the sockets to the lamp assembly.
Rotate the sockets clockwise to engage the locking tabs.
- Position the tail/backup lamp assembly to the rear fascia.
- Install the screws retaining the tail/backup lamp to the rear fascia.
Tighten: Tighten the tail/backup lamp retaining screws to 2 N.m (18 lb in).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.