SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 273 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSPARK/TURN SIGNAL/SIDE MARKER LAMP REPLACEMENTREMOVAL PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Cooling Duct To Front Fascia
    GM171878Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, and position the duct aside.
    4. Fig 2: Lamp Bracket To Front Fascia
    GM64639Courtesy of GENERAL MOTORS CORP.
  4. Remove the front turn signal lamp bracket retaining spring from the lamp bracket.
  5. Remove the lamp bracket retaining spring from the front fascia.
  6. Remove the front turn signal lamp bracket retaining screws.
    7. Fig 3: Sockets To Lamp
    GM64634Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the sockets from the lamp.
    8. Fig 4: Lamp To Bracket & Screws
    GM64641Courtesy of GENERAL MOTORS CORP.
  8. Remove the lamp, with the bracket, from the vehicle.
  9. Remove the lamp to bracket retaining screws.
  10. Remove the lamp from the bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.