Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 272 (STEERING WHEEL AND STEERING COLUMN)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2001 Chevrolet Cavalier LS, 2.4 T
Scan Tool Data List
2001 Chevrolet Cavalier LS, 2.4 TSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
BCM Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Column Feedback | Input Data 2 | Active/Inactive | Active |
| Column Lock State | Input Data 2 | Current State | Ignition On Unlocked |
| Column Lock/Unlock A | Input Data 2 | Active/Inactive | Inactive |
| Column Lock/Unlock B | Input Data 2 | Active/Inactive | Inactive |
| Current Power Mode | Input Data 1 | Power Mode | Run |
| Driver Door Ajar Switch | Input Data 2 | Open/Closed | Closed |
| Ignition 1 | Input Data 1 | On/Off | On |
| Ignition 2 | Input Data 1 | On/Off | On |
| Ignition 3 | Input Data 1 | On/Off | On |
| Key In Ignition | Input Data 1 | Active/Inactive | Active |
| Key Out of Ignition | Input Data 1 | Active/Inactive | Inactive |
| Passenger Door Ajar Switch | Input Data 2 | Open/Closed | Closed |
SCM Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Column Aft Motor Stop | Column Info | Volts | 0-5 Volts |
| Column Fore Mtr Stop | Column Info | Volts | 0-5 Volts |
| Column Fore/Aft Motor | Column Info | In/Out/Idle | Idle |
| Column Fore/Aft Switch | Column Info | In/Out/Idle | Idle |
| Column Position Fdbk | Column Info | Volts | 0-5 Volts |
| Memory 1 Stored Position | Column Info | Volts | 0-5 Volts |
| Memory 2 Stored Position | Column Info | Volts | 0-5 Volts |
| Memory 3 Stored Position | Column Info | Volts | 0-5 Volts |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.