Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 271 (ENGINE CONTROLS (INTRODUCTION) -- 5.7L)SPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2001 Chevrolet Cavalier LS, 2.4 T
Special Tools
2001 Chevrolet Cavalier LS, 2.4 TSECTION Special Tools
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Number/Description |
|---|---|
| J 22610 Service Boot Clamp |
|
| J 23738-A Vacuum Pump |
|
| J 26792 Spark Tester |
|
| J 34142-B Test Light |
|
| J 34730-1A Fuel Pressure Gauge |
|
| J 34730-2C Injector Test Light (EFI Lite) |
|
| J 35616-A Connector Test Adapter Kit |
|
| J 35800-A Fuel Injector Cleaner |
|
| J 36169-A Fused Jumper Wire |
|
| J 37088-A Fuel Line Quick Connect Separator |
|
| J 37287 Inlet and Return Fuel Line Shut off Adapters |
|
| J 39021 Fuel Injector Coil/Balance Tester |
|
| J 39200 Digital Multimeter |
|
| J 39765 Fuel Sender Lock Nut Wrench |
|
| J 41413-200 Evaporative Emissions System Tester (EEST) |
|
| J 41413-SPT High Intensity White Light |
|
| J 41413-306 EVAP Plug |
|
| J 41413-307 EVAP Plug |
|
| J 41413-311 EVAP Plug |
|
| J 41413-VLV EVAP Service Port Vent Fitting |
|
| J 41415-40 Fuel Tank Cap Adapter |
|
| J 41416 Ultrasonic Leak Detector |
|
| J 42236-A Serial Data Link Test |
|
| J 42598 Vehicle Data Recorder |
|
| J 43244 Relay Puller Pliers |
|
| J 44175 Fuel Composition Tester |
|
| J 45004 Fuel Tank Drain Hose |
|
| J 44602 Fuel Injector Test Adapter |
|
| J 44603 Fuel Injector Test Lamp |
|
| Tech 2 Kit 7000081 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.