SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 270 (WIRING SYSTEMS - SPECIFICATIONS, COMPONENT VIEWS AND CONNECTOR END VIEWS)COMPONENT LOCATORINLINE HARNESS CONNECTOR END VIEWSC202
2001 Chevrolet Cavalier LS, 2.4 T

Inline Harness Connector End Views: C202

2001 Chevrolet Cavalier LS, 2.4 TSECTION C202
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
C202 Instrument Panel Harness To Terminal Identification RH Door Harness

GM283830Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12064871
  • 10-Way F Metri-Pack 150 Series (BLU)
 Connector Part Information
  • 12064872
  • 10-Way M Metri-Pack 150 Series (BLU)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A LT GRN 200 Right Front Speaker Output (+) A LT GRN 200 Right Front Speaker Output (+)
B DK GRN 117 Right Front Speaker Output (-) B DK GRN 117 Right Front Speaker Output (-)
C BLK/WHT 351 Ground C BLK/WHT 351 Ground
D ORN 360 Speaker Supply Voltage D ORN 360 Speaker Supply Voltage
E BLK/WHT 351 Ground E BLK/WHT 351 Ground
F-G - - Not Used F-G - - Not Used
H ORN/BLK 1726 Audio Signal-RH Subwoofer H YEL 1726 Audio Signal-RH Subwoofer
J LT GRN 512 Right Front Low Level Audio Signal (+) J LT GRN 512 Right Front Low Level Audio Signal (+)
K Bare 514 Ground K Bare 514 Ground
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.