SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 270 (WIRING SYSTEMS - SPECIFICATIONS, COMPONENT VIEWS AND CONNECTOR END VIEWS)COMPONENT LOCATORINLINE HARNESS CONNECTOR END VIEWSC100
2001 Chevrolet Cavalier LS, 2.4 T

Inline Harness Connector End Views: C100

2001 Chevrolet Cavalier LS, 2.4 TSECTION C100
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
C100 Forward Lamp Harness Terminal Identification To Forward Lamp Jumper Harness

GM524196Courtesy of GENERAL MOTORS CORP.
GM365940Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12047932
  • 8-Way F Metri-Pack 150 Series (BLK)
 Connector Part Information
  • 12047931
  • 8-Way M Metri-Pack 150 Series (BLK)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A BRN 9 Park Lamp Supply Voltage A BRN 9 Park Lamp Supply Voltage
B BRN 9 Park Lamp Supply Voltage B BRN 9 Park Lamp Supply Voltage
C BRN 9 Park Lamp Supply Voltage C BRN 9 Park Lamp Supply Voltage
D BRN 9 Park Lamp Supply Voltage D BRN 9 Park Lamp Supply Voltage
E LT BLU/ WHT 1314 Left Front Turn Signal Lamp Supply Voltage E LT BLU/ WHT 1314 Left Front Turn Signal Lamp Supply Voltage
F DK BLU/ WHT 1315 Right Front Turn Signal Lamp Supply Voltage F DK BLU/ WHT 1315 Right Front Turn Signal Lamp Supply Voltage
G BLK 150 Ground G BLK 150 Ground
H - - Not Used H - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.