Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSLOWER BALL JOINT REPLACEMENTTOOLS REQUIREDREMOVAL PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T
Removal Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and suitably support the vehicle.
- Remove the tire and wheel assemblies.
- If the vehicle is equipped with a stabilizer shaft, remove the stabilizer shaft link. Refer to STABILIZER SHAFT REPLACEMENT .
- Remove the wiring harness from the lower control arm.
- Remove the cotter pin (1) from the ball joint (3).
- Remove the nut (4) from the ball joint (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.