Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 232 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPERS/WASHER SWITCH REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Cavalier LS, 2.4 T

Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connector to the windshield wiper switch (2).
Install the windshield wiper switch (2) to the column (6).
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the retaining screw to the windshield wiper switch (2).
Tighten: Tighten the screw to 4 N.m (36 lb in).

Fig 1: Installing Windshield Wiper Switch Retaining Screw
Courtesy of GENERAL MOTORS CORP.
Install the multifunction switch. Refer to Multifunction, Turn Signal Switch Replacement in Steering Wheel and Column.
Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
Connect the negative battery cable.
Ensure that the windshield wiper switch (2) functions properly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.