Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the ACCY position.
  2. Turn the wiper switch to the DELAY position.
  3. Turn the ignition OFF when the wiper arms are in the innerwipe position and not moving.
  4. Mark the position of the wiper arm on the windshield with tape.
  5. Disconnect the washer hose from the washer nozzle.
  6. Remove the wiper arm nut cover.
  7. Remove the wiper arm nut.
    Fig 1: Removing Wiper Arm Nut
    GM347706Courtesy of GENERAL MOTORS CORP.
  8. Using the J 39822Β  , remove the wiper arm from the wiper transmission. See Special Tools and EquipmentΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.