Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper arm onto the wiper transmission.
  2. Align the wiper arm to the tape marks on the windshield.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the wiper arm nut.

    Tighten:Β  Tighten the nut to 30 N.m (22 lb ft).

  4. Install the wiper arm nut cover.
    Fig 1: Installing Wiper Arm Nut
    GM347706Courtesy of GENERAL MOTORS CORP.
  5. Connect the washer hose to the washer nozzle.
  6. Remove the tape marks from the windshield.
  7. Inspect the wipers for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.