Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hook of the wiper arm through the opening in the wiper blade.
    Fig 1: Removing & Installing Wiper Blade At Wiper Arm Hook
    GM497492Courtesy of GENERAL MOTORS CORP.
  2. Position the wiper blade pivot in the inside radius of the wiper arm hook.
  3. Press the wiper blade pivot into the wiper arm hook until fully seated.
  4. Inspect the wipers for proper operation.
    Fig 2: View Of Wiper Blade Clip
    GM497481Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.