Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fender liner (3) to the front fender.
  2. Install the push-in retainers.
    Fig 1: Installing Front Fender Liner Push-In Retainers
    GM276965Courtesy of GENERAL MOTORS CORP.
  3. NOTE: Refer to FASTENER NOTICE .
  4. Install the screws from the fender liner to the fender.

    Tighten:Β  Tighten the screws to 2 N.m (18 lb in).

  5. Install the screws to the front fender liner to the front bumper fascia.

    Tighten:Β  Tighten the screws to 2 N.m (18 lb in).

    Fig 2: Installing Front Fender Liner Screws
    GM330141Courtesy of GENERAL MOTORS CORP.
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.