Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 225 (ENGINE COOLING SYSTEM - 2.2L (L61))DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2001 Chevrolet Cavalier LS, 2.4 T
Scan Tool Data List
2001 Chevrolet Cavalier LS, 2.4 TSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
Instrument Panel Cluster (IPC) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Low Coolant Lamp | Lamp Status | ON/OFF | OFF |
Body Control Module (BCM) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Low Coolant Level | BCM Data | ON/OFF | OFF |
Powertrain Control Module (PCM) 2.2 L (L61) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition Switch in RUN/Engine running/Automatic Transmission in PARK/Air Conditioner is OFF | |||
| ECT Sensor | Engine Data 1 Engine Data 2 Engine Data 3 EVAP Fuel Trim Misfire |
°C/°F | Varies |
| FC Relay 1 Command | Engine Data 2 | ON/OFF | OFF |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.