Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 219 (KEYLESS ENTRY SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2001 Chevrolet Cavalier LS, 2.4 T
Scan Tool Data List
2001 Chevrolet Cavalier LS, 2.4 TSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Key On, Engine Off | |||
| Battery Voltage | BCM Data | Volts | 13.0 volts |
| Door Lock Relay | Door Lock Data | ON/OFF | OFF |
| Door Lock Relay Fdbk. | Door Lock Data | Active/Inactive | Inactive |
| Driv Door Unlk Fdbk. | Door Lock Data | Active/Inactive | Inactive |
| Driver Door Unlock Relay | Door Lock Data | ON/OFF | ON |
| DRL Relay | Lamp Status | ON/OFF | OFF |
| DRL Relay Fdbk. | Lamp Status | Active/Inactive | OFF |
| Horn Relay | BCM Data | ON/OFF | OFF |
| Horn Relay Feedback | BCM Data | ON/OFF | OFF |
| Ignition 1 | BCM Data | ON/OFF | ON |
| Interior Lamp Output | Lamp Status | ON/OFF | OFF |
| Other Door Unlock Fdbk. | Door Lock Data | Active/Inactive | Inactive |
| Other Door Unlock Relay | Door Lock Data | ON/OFF | OFF |
| Passenger Door Unlock R | Door Lock Data | ON/OFF | OFF |
| Trunk Rel Sol Fdbk. | Door Lock Data | Active/Inactive | OFF |
| Trunk Release Solenoid | Door Lock Data | Active/Inactive | Inactive |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.