Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front seat pad and cover (1) to the front seat cushion frame (3).
  2. Connect the front seat pad and cover J-hook retainers (2) to the front seat cushion frame (3).
    Fig 1: Installing Front Seat Cover
    GM279078Courtesy of GENERAL MOTORS CORP.
  3. Install the front bucket seat back to the front seat cushion. Refer to Seat Back Replacement - FrontΒ .
  4. Install the front bucket seat. Refer to Seat ReplacementΒ .
  5. Enable the SIR system, if equipped with SIAB. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.