Installation Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the bottom of the seat back cover assembly (2) down and over the frame (11).
  2. Connect the J-hook retainer (1).
  3. Install the release lever knob (5) to the recliner (8), if equipped.
  4. Install the head restraint. Refer to Head Restraint Replacement - Front SeatΒ .
  5. Install the front bucket seat back. Refer to Seat Back Replacement - FrontΒ .
  6. Reposition the front seat back to the original position.
    Fig 1: Installing J-Hook Retainer (Without AJ7)
    GM826504Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.