Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 217 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK COVER REPLACEMENT - FRONT (WITH AJ7)INSTALLATION PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T
Installation Procedure
2001 Chevrolet Cavalier LS, 2.4 TSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Pull the bottom of the seat back cover assembly (2) down and over the frame (7).
- Fasten the J-hook retainer (1) located on the bottom of the seat back.
- If equipped, install the recliner release lever knob (8) to the recliner (11).
- Install the Side Impact Air Bag (SIAB) module. Refer to Inflatable Restraint Side Impact Module Replacement - Front in SIR.
- Install the seat back to the seat cushion frame. Refer to Seat Back Replacement - Front .
- Install the head restraint to the seat back. Refer to Head Restraint Replacement - Front Seat .
- Enable the SIR system. Refer toSIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.