Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. With a grease pencil, mark the location of the latch on the compartment lid.
  2. Remove the lock cable assembly (8).
  3. Unclip the cable door at the top of the lock release box (2) to expose the remote release cable, if equipped.
  4. Remove the remote release cable (1) from the lock release box, if equipped.
  5. Remove the latch cable assembly bolts (7).
    Fig 1: Removing Latch Cable Assembly Bolts
    GM283996Courtesy of GENERAL MOTORS CORP.
  6. Remove the latch assembly (3).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.