SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CAVALIER LS, 2.4 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 212 (ENGINE CONTROLS - 2.2L (L61) INTRODUCTION)REPAIR INSTRUCTIONSINTAKE AIR TEMPERATURE (IAT) SENSOR REPLACEMENTREMOVAL PROCEDURE
2001 Chevrolet Cavalier LS, 2.4 T

Removal Procedure

2001 Chevrolet Cavalier LS, 2.4 TSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the air cleaner duct from the air cleaner resonator.
  2. Disconnect the IAT sensor harness connector.
  3. While twisting the IAT sensor (4), pull the sensor from the air cleaner resonator (1).
    Fig 1: Locating IAT Sensor
    GM785335Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.